Bovine Bone Hidroksiapatite Materials Mechanics Properties at 900°C and 1200°C of Calcination Temperature
Abstract
The aims of this study is to determine the mechanical characteristics of the calcinated scaffold material bovine hydroxyapatite (BHA) for bone filler applications. Scaffold BHA was obtained from femur section of bovine bones which cut into 10x10x10 mm. Scaffold BHA was calcinated by temperature variations of 900ºC and 1200°C for 2 hours with 10ºC/min as the amount of the increasing level. The study result of each scaffold BHA which had been calcinated by 900°C and 1200°C has a hardness value of 8.48 ± 0.1118 VHN and 12.37 ± 0.5803, meanwhile the compressive strength value of each scaffold BHA samples is 3.03 ± 0.6764 MPa and 1.96 ± 0.3450 MPa. The porous on scaffold BHA samples calcinated by 900°C and 1200°C which had been observed by SEM had porous size that is not much different, it was ± 200-400 μm, the difference can be seen from the smaller porous size of the scaffold BHA calcination 1200°C compared to the porous size of scaffold BHA calcination 900°C.
Full Text:
PDFReferences
A.E., Tontowi, P., Dewo, E.T., Wahyuni, J., Triyono, Scaffold Dari Bovine Hydroxyapatite Dengan Poly Vynialchohol Coating, Jurnal Teknosains, Vol. 1 (2). 2012.
C., Ooi, M., Hamdi, S., Ramesh, Properties of Hydroxyapatite Produced by Annealing of Bovine Bone, Ceramics international, Vol. 33 (7), pp. 1171-1177. 2007.
F., Heidari, M., Razavi, M., Ghaedi, M., Forooghi, M., Tahriri, L., Tayebi, Investigation of Mechanical Properties of Natural Hydroxyapatite Samples Prepared by Cold Isostatic Pressing Method, Journal of Alloys and Compounds, Vol. 693 pp. 1150-1156. 2017.
A., Ruksudjarit, K., Pengpat, G., Rujijanagul, T., Tunkasiri, Synthesis and Characterization of Nanocrystalline Hydroxyapatite from Natural Bovine Bone, Current applied physics, Vol. 8 (3), pp. 270-272. 2008.
A., Niakan, S., Ramesh, P., Ganesan, C., Tan, J., Purbolaksono, H., Chandran, Sintering Behaviour of Natural Porous Hydroxyapatite Derived from Bovine Bone, Ceramics International, Vol. 41 (2), pp. 3024-3029. 2015.
A., Niakan, S., Ramesh, C., Tan, J., Purbolaksono, H., Chandran, W., Teng, Effect of Annealing Treatment on the Characteristics of Bovine Bone, Journal of Ceramic Processing Research, Vol. 16 (2), pp. 223-226. 2015.
Scalera, F., Gervaso, F., Sanosh, K., Sannino, A., and Licciulli, A., 2013, Influence of the Calcination Temperature on Morphological and Mechanical Properties of Highly Porous Hydroxyapatite Scaffolds, Ceramics International, Vol. 39 (5), pp. 4839-4846.
J.,Triyono, S., Susmartini, E., Susilowati, S.A., Murdiyantara, Shellac Coated Hydroxyapatite (Ha) Scaffold for Increasing Compression Strength, Advanced Materials Research. 2015.
A., Handayani, Preparation and characterization of Porous Hydroxyapatite from Fish Bone,
Refbacks
- There are currently no refbacks.
Mekanika: Majalah Ilmiah Mekanika
ISSN: 1412-7962 || eISSN: 2579-3144
Address : Jl. Ir Sutami no 36 A, Building I, Faculty of Engineering, Universitas Sebelas Maret, Surakarta.
Phone : +62271632163
email : mesin@ft.uns.ac.id
This work is licensed under a Creative Commons Attribution 4.0 International License