Analisis simulasi pengaruh ratio overlap sudu terhadap unjuk kerja savonius horizontal axis water turbine

Hasnul Khuluqi, Syamsul Hadi, Dominicus Danardono

Abstract


The rainwater which is harvested and flowed in a 3 inch diameter pipe has potential energy that can be used to generate the turbine generator for producing electricity. This paper was focused on horizontal axis savonius turbine with varied blade overlap ratio in picohydro generator. Savonius turbine is known to utilize the drag force and work efficiently at low velocity. The purpose of this research is to find out optimal torque of savonius water turbine, and flow distribution. The results showed that the flow rate of 11.9 l/s with the overlap variation of 0.3 obtained the maximum torque value of 5,22 Nm.

Full Text:

PDF

References


Chen J, dkk. "A novel vertical axis water turbine for power generation from water pipelines," Energy, vol. 54, pp. 184-193, 2013

Biswas, dkk. "Experimental and computational evaluation of Savonius hydrokinetic turbine for low velocity condition with comparison to Savonius wind turbine at the same input power," Energy Conversion and Management, vol. 83, pp. 88-98, 2014.

Patel, dkk. "Investigation Of Overlap Ratio For Savonius Type Vertical Axis Hydro Turbine," IJSCE ISSN: 2231-2307, vol.3, May 2013.

Wenehenubun F, dkk."An experimental study on the performance of savonius wind turbine related with the number of blades", 2nd International Conference on Sustainable Energy Engineering and Application. (ICSEEA-2014).

Ali M H., 2013., Experimental Comparation Study for Savonius Wind Turbine Of two & Three Blades At low Wind Speed, International Journal Of Modern Engineering Research (IJMER) Vol. 3, Issue. 5, Sep – Oct. 2013 pp – 2978 – 2986 ISSN : 2249 – 6645.

Myint Y W, Win H H 2014. Design and Flow Simulation of Runner Blade for Propeller Turbine, ISSN 2319-8885 Vol.03,Issue.11 June-2014, Pages:2559-2562.

Prasetyo H, dkk 2016. Simulasi Turbin Air Poros Horizontal Axis Water Turbine Dengan Menggunakan Aplikasi Flow Simulation SolidWorks. JURNAL MEKANIKA UNS, Volume-, No. 2 Maret 2016.


Refbacks

  • There are currently no refbacks.


Mekanika: Majalah Ilmiah Mekanika

ISSN: 1412-7962 || eISSN: 2579-3144

Address :  Jl. Ir Sutami no 36 A, Building I, Faculty of Engineering, Universitas Sebelas Maret, Surakarta.

Phone    :  +62271632163 

email     : mesin@ft.uns.ac.id

 

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License